Netgear ME101 User Manual download pdf (Page 9)

Installing the Configuration Utility

To configure the bridge you use the configuration utility on the included GearBox CD.

Note: To run the configuration utility, you must have the bridge directly connected using the

provided Ethernet crossover cable to a computer running Windows 98 or 98SE, Me, 2000, or

XP. If you have a Macintosh

computer, use the browser-based configuration procedure on

page 11.

1. Insert the GearBox CD in a networked computer’s CD-ROM drive.

The NETGEAR software installation utility should start up automatically.

2. Click Install Utility.

3. Follow the instructions on screen to install the ME101 Configuration Utility.

4. Click Finish.

5. Restart the computer.

6. If you had the bridge connected to another device, you must connect it to the computer

where you installed the Configuration Utility.

a. If you had the bridge powered up, unplug it.

b. Connect the provided Ethernet crossover cable

between the computer and the bridge.

c. Plug the power adapter into the bridge and

then plug the power adapter into a power

source.

Default Ethernet AntennaDC in 5V

ME101 Wireless

Ethernet Bridge

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

No comments

Netgear ME101 User Manual Page 9