Netgear ME101 User Manual download pdf (Page 13)

Using the Browser-based Configuration Software

If you don’t have access to a Windows-based computer,

you may use the internal browser-based configuration

software to configure the bridge.

1. Make sure the router or access point is powered up.

2. Power up the bridge.

3. Power down the Ethernet-enabled computer.

4. Connect the provided Ethernet crossover cable

between the computer and the bridge.

5. Power on the computer.

If your wireless network has an IP address other than

192.168.0.yyy, you’ll first need to change the IP address

on the bridge before making any other changes.

1. Note the current setting and manually change the IP address of your computer to

192.168.0.201. With a Macintosh computer use the Network control panel (OS X) or the

TCP/IP control panel (OS 9.x).

2. Start your browser software.

3. Type http://192.168.0.200 as the

Web address and press Return.

You’ll see the Information page.

4. To change the IP address for the

bridge to match your wireless

network, click IP Settings.

5. Type admin as the User ID and

type password as the Password.

6. Click OK.

7. Type the correct IP address for the

bridge. The first three sets of

numbers (xxx.xxx.xxx.yyy) should

be the same as your access point or router. The last set of numbers (.yyy) should be a set of

unique numbers on your network.

8. Click Apply.

9. Click Logout.

10. Restore the computer to its previous network settings. For example, if your network uses

DHCP, return your computer to that setting instead of the manual setting.

Default Ethernet AntennaDC in 5V

ME101 Wireless

Ethernet Bridge

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

No comments

Netgear ME101 User Manual Page 13