Netgear WNR2000v3 User Manual download pdf (Page 21)

Manually Installing Your Router 17

Setting Up Your Router for Internet Access

When configuring your wireless router manually, you must log in to your wireless router to set it

up initially and to make any changes to your wireless router’s settings later.

To access the router:

1. Type http://www.routerlogin.net in the address field of your browser, and then click Enter.

Figure 12

The factory default state is reset when you use the Restore Factory Settings button.

See “Restoring the Default Password and Configuration Settings” on page 36 for

more information.

You can enter either of these addresses to connect to your wireless router:

http://www.routerlogin.net or http://www.routerlogin.com.

WPS. The WPS button/light will not be lit unless you push it to enable

Push ‘N’ Connect (WPS) security. See “Using Push 'N' Connect (WPS)

to Configure Your Wireless Network” on page 23.

Power. The power light should turn solid green. If it does not, see

“Checking Basic Router Functions” on page 27.

Wireless. The wireless light should be lit after turning on the wireless

router.

Internet. The Internet port light should be lit. If it is not, make sure the

Ethernet cable is securely attached to the wireless router Internet port

and the modem, and that the modem is powered on.

LAN. A LAN light (1-4) should be lit for each connected computer on

your network. Green indicates that your computer is communicating at

100 Mbps; amber indicates communication at 10 Mbps. If a LAN light is

not lit for each connected Ethernet cable, make sure that the Ethernet

cable from the computer to the router is securely attached at both ends,

and that the computer is turned on.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

No comments

Netgear WNR2000v3 User Manual Page 21