Netgear R6200 User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 131
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
Hardware Setup
9
R6200v2 Smart WiFi Router
Front and Side Panels
The router front and side panels have the status LEDs and buttons shown in the following
figure.
LEDs
WiFi On/Off button
WPS button
Figure 2. Router front and side view
Table 1. Front panel LED descriptions
LED Description
Power
Solid amber. The router is starting.
Blinking amber.
The firmware is upgrading, or the Reset button was pressed.
Solid green. The
router is ready.
Blinking green. The
firmware is corrupted. Visit www.netgear.com/support.
Off. Power is not supplied to the router
.
Internet
Solid green. The Internet connection is ready.
Solid amber.
The Ethernet cable connection to the modem has been detected.
Off. No Ethernet cable is connected to the modem.
Wireless
Solid blue. The wireless radio is operating in either 2.4 GHz or 5 GHz mode.
Blinking. The
router is in WPS mode.
Off.
The wireless radios are off for both 2.4 GHz and 5 GHz.
USB Solid blue. The router has accepted the USB device. The USB device is ready to be used.
Blinking blue.
A USB device is plugged in and is trying to connect.
Off. No USB device is connected;, or someone clicked the Safely Remove Hardware button,
and it is now safe to remove the attached USB device.
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 130 131

Comments to this Manuals

No comments