Netgear WMS5316 User Manual download pdf (Page 52)

52 | Chapter 7: Maintenance

ProSafe 16 AP Wireless Management System WMS5316 Reference Manual

3. On the Maintenance tab select Upgrade > System Upgrade:

4. On the Upgrade screen, click Browse.

5. Locate and select the file you downloaded.

6. Click Apply to send the software to the wireless management system.

This loads the new software into the wireless management system and causes the

wireless management system to restart.

Note: Do not try to go online, turn off the wireless management system,

shut down the computer, or do anything else to the wireless

management system until it finishes restarting! When the Test light

turns off, wait a few more seconds before doing anything.

7. Check the Monitoring screen to see the firmware version to verify that the new software is

installed.

Upgrading Access Point Firmware

You can install a new version of the access point’s firmware using the Access Point Upgrade

screen.

WARNING!

In some cases, such as a major upgrade, you might need to erase

the configuration of your access point after upgrading it.

See the Release Notes included with the software to find out if you need to reconfigure the

access point. Reconfiguring access points already managed by the wireless management

system requires only the IP address to be set manually. The wireless management system

restores configuration for already managed access points running the supported firmware

version.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 65 66

No comments

Netgear WMS5316 User Manual Page 52