Netgear GS748T User Manual download pdf (Page 29)

GS748T Smart Switch Hardware Installation Guide

Installation 4-5

v1.0, January 2007

Figure 4-3 Installing a SFP GBIC Module into GS748T

Step 6: Applying AC Power

Because he NETGEAR GS748T Gigabit Smart Switch has no ON/OFF switch, AC power must be

controlled by means of the IEC power cord connection. Select an appropriate unswitched,

grounded AC facility outlet so as to avoid any future inadvertent power interruptions. Use the

following procedure to apply AC power:

1. Connect the female end of the supplied IEC AC power adapter cable to the power receptacle

on the back of the switch.

2. Connect the 3-pronged end of the AC power adapter cable to the AC outlet.

When you apply power, the green Power LED on the switch front panel illuminates.

Note: If the Power LED does not light, check that the power cable is installed correctly

and that the AC power supply is present. If this does not resolve the problem, refer

Appendix A, “Troubleshooting”.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

No comments

Netgear GS748T User Manual Page 29