Netgear FSM726 User Manual download pdf (Page 23)

Page 22 of 22

Configuration

If problems occur after altering the network configuration, restore the original connections and determine

the problem by implementing the new changes, one step at a time. Make sure that cable distances,

repeater limits, and other physical aspects of the installation do not exceed the Ethernet limitations.

Switch Integrity

If required, verify the integrity of the switch by resetting the switch. To reset the switch, use the Tools>

Reset command or remove AC power from the switch and then reapply AC power. If the problem continues,

contact NETGEAR technical support. In North America, call 1-888-NETGEAR. If you are outside of North

America, please refer to the support information card included with your product.

Auto Negotiation

The 10/100 Mbps ports negotiate the correct duplex mode and speed if the device at the other end of the

link supports auto negotiation. If the device does not support auto negotiation, the switch only determines

the speed correctly and the duplex mode defaults to half-duplex.

The gigabit port on the Gigabit module negotiates speed, duplex mode, and flow control, provided that the

attached device supports auto-negotiation.

1 2 ... 18 19 20 21 22 23 24 25

No comments

Netgear FSM726 User Manual Page 23