Netgear FSM726 User Manual download pdf (Page 15)

Page 14 of 14

Step 2: Installing the Switch

You can install your NETGEAR Model FSM726 Managed Switch on a flat surface or in a standard 19-inch

rack.

Installing the Switch on a Flat Surface

The switch ships with four self-adhesive rubber footpads. Stick one rubber footpad on each of the four

concave spaces on the bottom of the switch. The rubber footpads cushion the switch against

shock/vibrations.

Installing the Switch in a Rack

To install the switch in a rack, use the following procedure (and refer to Figure 3-1). To perform this

procedure, you need the 19-inch rack-mount kit supplied with your switch.

1. Attach the supplied mounting brackets to the side of the switch.

2. Insert the screws provided in the rack-mount kit through each bracket and into the bracket mounting

holes in the switch.

3. Tighten the screws with a #1 Phillips screwdriver to secure each bracket.

4. Align the mounting holes in the brackets with the holes in the rack, and insert two pan-head screws

with nylon washers through each bracket and into the rack.

5. Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.

Figure 3-1. Attaching Mounting Brackets

Step 3: Checking the Installation

Before you apply power:

o Inspect the equipment thoroughly.

o Verify that all cables are installed correctly.

o Check cable routing to make sure cables are not damaged or create a safety hazard.

o Be sure all equipment is mounted properly and securely.

Step 4: Applying AC Power

NETGEAR Model FSM726 Managed Switch does not have an ON/OFF switch; the only method of applying

or removing AC power is by connecting or disconnecting the power cord. Before you connect the power

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

No comments

Netgear FSM726 User Manual Page 15