Netgear FSM726 User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 25
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
Page 13 of 13
CHAPTER 3: INSTALLATION
This chapter describes the installation procedures for your NETGEAR Model FSM726 Managed Switch.
Switch installation involves the following steps:
Step 1: Preparing the site
Step 2: Installing the switch
Step 3: Checking the installation
Step 4: Applying AC power
Step 5: Connecting devices to the switch
Step 6: Installing a GBIC module
Step 7: Connecting to the console port to manage the switch (initial configuration)
Step 1: Preparing the Site
Before you install your switch, be sure your operating environment meets the operating environment
requirements in Table 3-1.
Table 3-1. Site Requirements
Characteristics Requirements
Mounting
Desktop installations:
Rack-mount installations:
Provide a flat table or shelf surface.
Use a 19-inch (48.3-centimeter) EIA standard equipment rack that is grounded
and physically secure. You also need the rack-mount kit supplied with your
switch.
Access
Locate the switch in a position that lets you access the front panel RJ-45 ports,
view the front panel LEDs, and access the rear-panel power connector.
Power source
Provide a power source within 6 feet (1.8 meters) of the installation location.
Power specifications for the switch is shown in Appendix C. Be sure the AC
outlet is not controlled by a wall switch, which can accidentally turn off power
to the outlet and the switch.
Environmental
Temperature: Install the switch in a dry area, with ambient temperature between 0
and 40ºC (32 and 104ºF). Keep the switch away from heat sources
such as direct sunlight, warm air exhausts, hot-air vents, and heaters.
Operating humidity: The installation location should have a maximum relative humidity of
90%, non-condensing.
Ventilation: Do not restrict airflow by covering or obstructing air inlets on the sides
of the switch. Keep at least 2 inches (5.08 centimeters) free on all sides
for cooling.
Be sure there is adequate airflow in the room or wiring closet where you
intend to install the switch.
Operating conditions: Keep the switch at least 6 ft (1.83 m) away from nearest source of
electromagnetic noise, such as a photocopy machine.
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Comments to this Manuals

No comments