Netgear WN604 User's Guide download pdf (Page 56)

Troubleshooting

Wireless N150 Access Point WN604

Troubleshooting with the LEDs

You can use the LEDs on the front panel of the access point for troubleshooting.

All LEDs Are Off

It takes a few seconds for the Power LED to light up. Wait a minute and check the Power LED

again.

If the access point has no power.

• Make sure the power adapter is connected to the access point..

• Make sure the power adapter is connected to a functioning power outlet. If it is in a power

strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify

that it is not a switched outlet.

• Make sure you are using the correct NETGEAR power adapter supplied with your access

point.

WiFi LED Is Off

The wireless radio is turned off or the antenna is not working. There are two ways to turn off

the wireless radio--the Wireless On/Off button on the side of the access point, and the

Schedule Wireless Radio feature.

Wireless On/Off

Figure 7. You can use the Wireless On/Off button to control the wireless radio

For information about the Schedule Wireless Radio feature, see Schedule the Wireless Radio

on page 46.

Check the following:

1. Make sure that the wireless radio is turned on. If it is, and the WiFi LED stays of

disconnect the access point from its power source and then plug it in again.

2. Make sure the antenna is securely connected to the access point.

3. Contact NETGEAR technical support if the WiFi LED remains of

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 67 68

No comments

Netgear WN604 User's Guide Page 56