Netgear WG302 User Manual Page 66
- Page / 128
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
4-10 Management
July 2005 v3.0
Upgrading the Wireless Access Point Software
.
You cannot perform the firmware upgrade from a workstation connected to the WG302 via a
wireless link. The firmware upgrade must be performed via a workstation connected to the
WG302 via the Ethernet LAN interface.
The software of the WG302 Access Point is stored in FLASH memory, and can be upgraded as
new software is released by NETGEAR. Upgrade files can be downloaded from Neater’s Web site.
If the upgrade file is compressed (.ZIP file), you must first extract the image (.RMG) file before
sending it to the wireless access point. The upgrade file can be sent using your browser.
Note: The Web browser used to upload new firmware into the WG302 must support HTTP
uploads, such as Microsoft Internet Explorer 6.0 or above, or Netscape Navigator 4.78 or above.
1. Download the new software file from NETGEAR, save it to your hard disk, and unzip it.
2. From the main menu Management section, click the Upgrade Firmware link to display the
screen above.
3. In the Upgrade Firmware menu, click the Browse button and browse to the location of the
image (.RMG) upgrade file.
4. Click Upload.
When the upload completes, your wireless access point will automatically restart. The upgrade
process typically takes about one minute.
In some cases, you may need to reconfigure the wireless access point after upgrading.
Note: When uploading software to the WG302 Access Point, it is important not to
interrupt the Web browser by closing the window, clicking a link, or loading a new page.
If the browser is interrupted, the upload may fail, corrupt the software, and render the
WG302 completely inoperable.
- Reference Manual for the 1
- NETGEAR ProSafe Wireless 1
- Access Point 802.11g WG302 1
- Technical Support 2
- Trademarks 2
- Statement of Conditions 2
- Radio Frequency Notice 3
- DECLARATION OF CONFORMITY 4
- Contents 7
- Chapter 1 11
- About This Manual 11
- How to Use This Manual 12
- How to Print this Manual 13
- 1-4 About This Manual 14
- Chapter 2 15
- Introduction 15
- Key Features 16
- Introduction 2-3 17
- 2-4 Introduction 18
- System Requirements 19
- What’s In the Box? 20
- Hardware Description 20
- Introduction 2-7 21
- Figure 2-2: WG302 rear panel 21
- 2-8 Introduction 22
- Chapter 3 23
- Cabling Requirements 24
- Default Factory Settings 25
- 6HFXULW\2SWLRQV 26
- 5DQJH8SWR)RRW5DGLXV 26
- ET UP THE WG302 ACCESS POINT 27
- Figure 3-2: Login window 28
- EPLOY THE WG302 ACCESS POINT 31
- 4VERIFY WIRELESS CONNECTIVITY 32
- Figure 3-7: IP Settings menu 34
- How to Configure WEP 43
- How to Configure WPA-PSK 47
- How to Configure WPA2-PSK 50
- Chapter 4 57
- Management 57
- 4-2 Management 58
- CLI Commands 59
- 4-4 Management 60
- Management 4-5 61
- 4-6 Management 62
- Statistics 63
- 4-8 Management 64
- Management 4-9 65
- Configuration File Management 67
- Apply to save your change 69
- 4-14 Management 70
- Chapter 5 71
- Advanced Configuration 71
- AutoCell RF Management 72
- Advanced Configuration 5-3 73
- 5-4 Advanced Configuration 74
- Wi-Fi Multimedia (WMM) Setup 75
- 5-6 Advanced Configuration 76
- Hotspot Settings 77
- 5-8 Advanced Configuration 78
- Hub or Switch 79
- 192.168.0.1 80
- Segment 1 81
- 5-12 Advanced Configuration 82
- Chapter 6 83
- Troubleshooting 83
- The LAN light is not lit 84
- Troubleshooting 6-3 85
- Appendix A 87
- Specifications 87
- A-2 Specifications 88
- Appendix B 89
- Wireless Networking Basics 89
- 802.11 Authentication 91
- Open System Authentication 91
- Shared Key Authentication 92
- Overview of WEP Parameters 93
- Key Size 94
- Wireless Channels 95
- How Does WPA Compare to WEP? 97
- Wired Network with Optional 100
- 802.1x Port Based Network 100
- Access Control 100
- Wireless LAN 100
- July 2005 v3.0 103
- Product Support for WPA/WPA2 104
- Is WPA/WPA2 Perfect? 104
- Appendix C 107
- Command Line Reference 107
- C-6 Command Line Reference 112
- Glossary 113
- 802.11e Standard 114
- 802.11g Standard 114
- 802.11i 114
- 802.11n Standard 114
- Access Point (AP) 115
- Ad-Hoc mode 115
- Bandwidth 115
- Bits per second (bps) 115
- Client or Client devices 116
- Collision avoidance 116
- Crossover cable 116
- 6 Glossary 118
- IEEE 802.11 119
- Infrastructure mode 119
- ISO Network Model 119
- MAC (Media Access Control) 120
- Mesh Networks 120
- Network name 120
- 10 Glossary 122
- 12 Glossary 124
- War Driving 125
- Wi-Fi (Wireless Fidelity) 125
- Wi-Fi Protected Access (WPA) 125
- 14 Glossary 126
- Wireless Multimedia (WMM) 127
- Wireless Networking 127
- WLAN (Wireless LAN) 127
Related products and manuals for WLAN access points Netgear WG302
WLAN access points Netgear WG102 User Manual
(102 pages)
(102 pages)
WLAN access points Netgear WG602 User Manual
(120 pages)
(120 pages)
WLAN access points Netgear WGR614v7 User Manual
(154 pages)
(154 pages)
WLAN access points Netgear WAG302v2 User Manual
(104 pages)
(104 pages)
WLAN access points Netgear WG602 User Manual
(15 pages)
(15 pages)
(78 pages)
WLAN access points Netgear WNAP210 User Manual
(126 pages)
(126 pages)
© 2020, manymanuals.com. All rights reserved. | 0.624 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals