Netgear WG302 User Manual download pdf (Page 58)

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

4-2 Management

July 2005 v3.0

• Private Community Name: The community string to allow the SNMP manager to read and

write the wireless access point's MIB objects. The default is private.

• IP address to Receive Traps: The IP address of the SNMP manager to receive traps sent from

the wireless access point. The default is 0.0.0.0.

Using the Secure Telnet Interface

The WG302 includes a secure Telnet command line interface (CLI). You can access the CLI from

a secure Telnet client over the Ethernet port or over the serial console port.

How to Use the CLI via the Console Port

1. Using the null-modem cable, connect a VT100/ANSI terminal or a workstation to the

port labeled Console.

If you attached a PC, Apple Macintosh, or UNIX workstation, start a secure

terminal-emulation program.

2. Configure the terminal-emulation program to use the following settings:

• Baud rate: 9,600 bps

• Data bits: 8

• Parity: none

• Stop bit: 1

• Flow control: none

These settings appear below the connector on the back panel.

Note: You must use a secure Telnet client such as Absolute Telnet. Also, when you

configure the client, use the SSH1, 3DES option. If you use the Telnet client to connect

over the Ethernet port, use the IP address of the WG302 as the host name.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 127 128

No comments

Netgear WG302 User Manual Page 58