Netgear WNDR4500 User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 126
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
Table 1. Front panel LED descriptions
LED Description
Power/Test
Solid amber. The unit is starting up after being powered on.
Solid green. The power is on, and the router is ready.
Blinking amber. A firmware update is in progress.
Blinking green. The firmware is corrupt.
Off. Power is not supplied to the router.
Internet
Solid amber. The IP address has not been acquired.
Solid green. An IP address has been received; ready to transmit data.
Off. No Ethernet cable is connected between the router and the modem.
2.4 GHz
Solid blue. The wireless radio is operating.
Off. The wireless radio is off.
5 GHz
Solid blue. The wireless radio is operating.
Off. The wireless radio is off.
LAN ports
1–4
Solid green. The LAN port has detected a 1,000 Mpbs link with an attached device.
Solid amber. The LAN port has detected a 10/100 Mbps link with an attached device.
Off. No link is detected on this port.
USB
(2 LEDs)
Solid. The USB device had been accepted by the router and is ready to be used.
Blinking. The USB device is in use.
Off. No USB device is connected, or the Safely Remove Hardware button has been clicked
and it is now safe to remove the attached USB device.
Hardware Setup
10
N900 Wireless Dual Band Gigabit Router WNDR4500
The WLAN and WPS buttons toggle the WLAN and WPS functions on and off.
WLAN On/Off button. Pressing and holding the wireless LAN button for 2 seconds
turns the 2.4 GHz and 5 GHz wireless radios on and off. If the 2.4 GHz and 5 GHz LEDs
are lit, then the wireless radio is on. If these LEDs are off, then the wireless radios are
turned off and you cannot connect wirelessly to the router.
WPS button. You can use this button to use WPS to add a wireless device or
computer to your wireless network. The LED below the WPS button blinks green when
the router is trying to add the wireless device or computer. The LED stays solid green
when wireless security is enabled in the router.
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 125 126

Comments to this Manuals

No comments