Netgear WNCE3001-100NAS User Manual download pdf (Page 7)

Getting Started

Universal Dual Band WiFi Internet Adapter (WNCE3001)

 To install your Internet adapter:

1. Carefully peel off the protective film covering your adapter.

Figure 5. Peel off the protective film

2. You use a computer to set up the Internet adapter. During setup, make sure that your

computer is not connected to a router. You can restore the connection after the Internet

adapter installation is complete.

• Disconnect the Ethernet cable from your computer if you use it for a wired network

connection.

• If your computer is wirelessly connected to a network, stop your wireless connection.

3. Connect the Internet adapter to your computer.

Figure 6. Connect the Internet adapter to your computer

• Use an Ethernet cable (included) to connect the Internet adapter to your computer.

• Use either the USB power cable or the power adapter to provide power to the Internet

adapter. See Power Connection Options on page 6.

4. Open your Internet browser. It automatically displays the setup page. If the setup page is not

displayed, type either http://www.mywifiext.net, http://www.mywifiext.com,

http://mywifiext.net, or http://mywifiext.com as the browser address. You can use any of

these four browser addresses to log in to the Internet adapter.

Note: Internet Explorer records the browser address. If the Internet adapter's IP address

subsequently changes and you are still using Internet Explorer, you have to use one of

the other browser addresses to access the device.

5. Follow the instructions on the Setup page.

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

No comments

Netgear WNCE3001-100NAS User Manual Page 7