Netgear STM150 User Manual download pdf (Page 569)

100

101

xDSL Network Module for the UTM9S and UTM25S

569

ProSecure Unified Threat Management (UTM) Appliance

Figure 334.

3. Configure the protocol binding settings as explained in the following table:

Table 146. Add Protocol Binding screen settings

Setting Description

Service From the drop-down list, select a service or application to be covered by this rule. If the

service or application does not appear in the list, you need to define it using the Services

screen (see Outbound Rules (Service Blocking) on page 129).

Local Gateway From the drop-down list, select the DSL interface or one of the WAN interfaces.

Source Network The source network settings determine which computers on your network are affected by

this rule. Select one of the following options from the drop-down list:

Any All devices on your LAN.

Single address In the Start IP field, enter the IP address to which the rule is applied.

Address Range In the Start IP field and End IP field, enter the IP addresses for the

range to which the rule is applied.

Group 1–Group 8 If this option is selected, the rule is applied to the devices that are

assigned to the selected group.

Note: You can also assign a customized name to a group (see

Change Group Names in the Network Database on page 115).

Destination

Network

The destination network settings determine which Internet locations (based on their IP

address) are covered by the rule. Select one of the following options from the drop-down

list:

Any All Internet IP address.

Single address In the Start IP field, enter the IP address to which the rule is applied.

Address range In the Start IP field and End IP field, enter the IP addresses for the

range to which the rule is applied.

1 2 ... 564 565 566 567 568 569 570 571 572 573 574 ... 703 704

Comments to this Manuals

No comments

Netgear STM150 User Manual Page 569

Comments to this Manuals

Related products and manuals for Routers Netgear STM150