Netgear FS526T User Manual download pdf (Page 18)

Smart Switch Series Software Manual

4-4 Web-Based Management Interface

July 2005

• The DHCP function is enabled by default. Click Static IP Address to disable the DHCP

function.

• Enter site-specific IP address, Subnet mask and Gateway in the appropriate boxes

• Click Apply to activate the setting

System> Password Page

The password entered is encrypted on the screen and will display as a sequence of asterisks (*).

The default password is ‘password’ and can be changed here.

• Type the old password in the Old Password field

• Type the new password in the New Password field

• Re-type the new password in the Re-type New Password field

• Click Apply to activate the new password

Note: The password is case sensitive and with a maximum length of 20.

Switch Menu

There are 4 options available:

• Port Configuration

• Statistics

• VLAN

•Trunking

Switch> Port Configuration Page

You can configure the status per port by clicking a port ID at the port setting menu.

• ID: The port number on the switch. Click this number to configure the port.

• Speed: Indicates the communication mode set for the port. The default setting for all ports is

Auto-negotiation (Auto). The possible entries are Auto-negotiation (Auto), 10 Mbps half

duplex (10M Half), 10 Mbps full duplex (10M Full), 100 Mbps half duplex (100M Half), 100

Mbps full duplex (100M Full), or Disable.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

No comments

Netgear FS526T User Manual Page 18