Netgear WG602V4 User Manual download pdf (Page 29)

NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual

Installation and Configuration 2-9

v1.0, June 2007

Logging Into the WG602v4

The NETGEAR WG602v4 54 Mbps Wireless Access Point can be configured remotely from

Microsoft Internet Explorer browser version 5.0 or above, or Netscape Navigator Web browser

version 4.78 or above, or Mozilla Firefox. You can log in to the WG602v4 in these two ways:

• Using the IP Address of the WG602v4 (if DHCP client is disabled) or with a reserved IP

address assigned by your router (if DHCP client is enabled). Either one of these methods is the

most reliable.

• Using the NetBIOS name of the WG602v4, which is not as reliable as using an IP Address.

IP Address Login

The default IP address of your wireless access point is 192.168.0.227. However, if you have

disabled DHCP client (fixed or static IP address), you can change the IP Address and IP Subnet

Mask of your wireless access point.

To connect to the WG602v4 using a fixed, static or reserved IP address:

1. Open a Web browser.

2. Enter the IP Address of WG602v4 into your browser (the default IP address is

http://192.168.0.227).

Note: If you are using the default IP subnet, the computer you are using to connect to the

WG602v4 should be configured with an IP address that starts with 192.168.0.x and

a Subnet Mask of 255.255.255.0; if you have changed the subnet of the wireless

access point, the computer your are using to connect must be within the same

subnet.

Figure 2-6

http://192.168.0.227

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 77 78

No comments

Netgear WG602V4 User Manual Page 29