Netgear DGND3700B User Manual download pdf (Page 102)

Advanced Settings

102

N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700v2

Wireless Repeater. The wireless modem router sends all traffic from its local wireless or

wired computers to a remote access point. To configure this mode, you have to know the

MAC address of the remote parent access point.

The DGND3700v2 wireless modem router is always in dual-band concurrent mode, unless

you turn of

f one radio. Be aware that if you enable the wireless repeater in either radio band,

the wireless base station or wireless repeater cannot be enabled in the other radio band.

However, if you enable the wireless base station in either radio band and use the other radio

band as a wireless wireless modem router or wireless base station, dual-band concurrent

mode is not affected.

For you to set up a wireless network with WDS,

the following conditions have to be met for

both access points:

• Both access points have to use the same SSID, wireless channel, and encryption mode.

• Both access points have to be on the same LAN IP subnet.

That is, all the access point

LAN IP addresses are in the same network.

• All LAN devices (wired and wireless computers) have to be configured to operate in the

same LAN network address range as the access points.

Wireless Repeating Function

Select Advanced > Advanced Setup > Wireless Repeating Function to view or change

wireless repeater settings for the wireless modem router.

• Enable Wireless Repeating Function. Select the check box for the 2.4 GHz or 5 GHz

network to use the wireless repeating function.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 151 152

No comments

Netgear DGND3700B User Manual Page 102