Netgear WG602v2 User's Guide download pdf (Page 52)

Reference Manual for the WG602 v2 54 Mbps Wireless Access Point

5-4 Advanced Configuration

M-10181-03

Configure AP1 in Point-to-Point mode with the MAC address of AP2 and deploy it on LAN

Segment 1. If you check the Enable Wireless Client Association checkbox, wireless clients

will also be able to use AP1. If the Enable Wireless Client Association checkbox is not

selected, only computers on Ethernet LAN segment 1 will use AP1 to communicate with AP2.

3. Configure AP2 in Point-to-Point mode with the MAC address of AP1 and deploy it on LAN

Segment 2. Use the same security and channel settings as AP1. If you check the Enable

Wireless Client Association checkbox, wireless clients will also be able to use AP2. If the

Enable Wireless Client Association checkbox is not selected, only computers on Ethernet

LAN segment 2 will use AP2 to communicate with AP1.

4. Verify connectivity across the network.

If you enabled wireless client association on both APs, a computer on either AP should be able

to connect to the Internet or share files and printers of any other PCs or servers connected to

the network.

How to Configure Wireless Multi-Point Bridging

Figure 5-4: Wireless Bridging

Verify the following parameters for all access points:

Note: The 54 Mbps Wireless Access Point WG602 v2 bridging and repeater modes are

only compatible with the NETGEAR WG602v2 and the NETGEAR WG302 Wireless

Access Points.

AP2

ETHERNET

LAN

Segment 1

192.168.0.1

Router

Hub or Switch

LAN

Segment 3

LAN

Segment 2

Hub or Switch

AP3

ETHERNET

AP1

ETHERNET

Wireless PC Card

in a Notebook Computer

Point-to-Multipoint

Mode

Point-to-Point

Mode

Point-to-Point

Mode

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 121 122

Comments to this Manuals

No comments

Netgear WG602v2 User's Guide Page 52

Comments to this Manuals

Related products and manuals for WLAN access points Netgear WG602v2