Netgear PS111W User Manual download pdf (Page 7)

Rear Panel

Label Function Description

PRINTER Parallel Accepts an IEEE1284 printer cable that connects

Printer Port to the printer.

NETWORK 10/100 Auto-sensing 10/100 Mbps Ethernet port for direct

BASE-T connection to a 10 Mbps or 100 Mbps port on a switch

Network Port or hub.

A small Diagnostic Briefly pressing the button has no effect. Pressing the

button and Restore- button for two seconds will print the status of the print

with no to-default server, including wired and wireless information, on the

label Button attached printer.

Note: This is the best way to obtain the IP address

of the print server, since the default setting for the

PS111W is DHCP.

Turn the power off, hold the Reset Button.

Powering on the print server and holding this button for

more than 10 seconds will restore the print server to the

factory default settings.

Warning: You will lose the current configuration in

the PS111W, so use this function with care.

12V DC Power Supply Accepts the 12V 800mA power supply.

Inlet

Note: NETGEAR advises that you use genuine

NETGEAR accessories to avoid damaging the unit.

For part re-ordering, please refer to the Replacement

Power Adapter section at the end of this guide.

NETWORKPRINTER

12V DC

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

No comments

Netgear PS111W User Manual Page 7