Netgear 802.11g User Manual download pdf (Page 23)

Note: For more troubleshooting information, go to the NETGEAR, Inc. web site.

• If the wireless LAN setting are

correct, make sure all the devices

are on the same IP network.

• Make sure the Ethernet cable

connectors are plugged into the

computer and bridge securely.

• You may need to change the IP

address of your computer

temporarily to change the bridge’s

IP address. See page 8.

• Reset to factory defaults. See pg.18.

I can’t get the

configuration utility

to show the bridge.

or

I can’t open the

configuration

software with my

browser.

This could be a network

configuration problem or

a hardware connection

problem.

My bridge-enabled

computer could not

communicate with

my wireless-enabled

computer or printer.

This most likely is a

network configuration

problem.

Symptom

Cause

Solution

• Check that the wireless-enabled

computer or printer is on the same

wireless network as the computer

using the bridge.

• Make sure the Network Name

(SSID), WEP key (if WEP is

enabled), and country/region

selection are the same for all devices

connected to the same wireless

network.

• If the computer is connected to the

bridge through a switch or hub, try

connecting it directly to the bridge.

21

I have a gaming

console, computer,

and the bridge

connected through a

switch. The

computer connects

to the Internet but

the gaming console

can’t.

If using a switch or hub

with an Ethernet-enabled

gaming console, the

gaming console must be

powered on before the

other Ethernet-enabled

devices.

• With power on, disconnect

everything from the switch or hub.

Re-connect the WGE101, then

connect the game console(s).

Finally, connect the other

device(s).

1 2 ... 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments