Netgear WNR834Bv2 User Manual download pdf (Page 40)

36 Default Configuration

Restoring the Default User Name and Password

You can restore the factory default configuration settings that reset the router’s User Name to

admin, the Password to password, and the IP address to 192.168.1.1. This procedure erases your

current configuration and restores the factory defaults.

To restore the factory default configuration settings:

Use a sharp object such as a pen or a paper clip to press and hold the default reset button,

located on the rear panel of the router, for about 20 seconds (see “Back Panel” on page 3).

2. Release the reset button and wait for the router to reboot.

Time Zone Adjusted for Daylight Saving

Time

Disabled

Firewall

Inbound (communications coming in from

the Internet)

Disabled (bars all unsolicited requests except for

traffic on port 80, the http port)

Outbound (communications going out to

the Internet)

Enabled (all)

Wireless

Wireless Communication Enabled

SSID Name NETGEAR

Security Disabled

Broadcast SSID Enabled

Transmission Speed Auto

Country/Region United States (North America only; otherwise varies

by country and region)

RF Channel 6 until region selected

Operating Mode 130 Mbps

Data Rate Best

Output Power Full

a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary. Network

conditions and environmental factors, including volume of network traffic, building materials and construction, and net-

work overhead lower actual data throughput rate.

Table 1. Home Router Default Configuration Settings (continued)

Feature Default Setting

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46

No comments

Netgear WNR834Bv2 User Manual Page 40