Netgear WNA1000 User's Guide Page 52

  • Download
  • Add to my manuals
  • Print
  • Page
    / 58
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 51
NETGEAR Wireless-N 150 USB Adapter WNA1000 User Manual
4-2
v1.0, August 2009
I cannot connect to a router or access point.
The router is available, and there is good
signal strength.
If the router is WPA-PSK protected, you need the correct
WPA-PSK passphrase. Otherwise, the WNA1000 might still
be connected to the previous connection, and you cannot
change to the WPA-PSK router.
If the router is WEP protected (either 64- or 128- bit
encryption), you are prompted to enter the WEP encryption
security information.
The connection status in the Status Bar
shows that I am connected to a router or
access point, but not to the Internet.
Check the router’s Internet connection.
Throughput is only 54 Mbps or only 14
Mbps.
The wireless-N USB adapter can operate at faster speeds.
At 54 Mbps you are probably connecting to a standard
802.11g network. See Chapter 3, “Wireless Network
Performance”.
If you do not have a USB 2.0 port on your PC, the
throughput is limited to the 14 Mbps of the USB 1.1
standard.
The Smart Wizard keeps asking me to save
settings.
If you change the settings, the Smart Wizard offers you the
chance to save the changes. To avoid this prompt, simply click
Apply before you close the Smart Wizard.
Two WNA1000 icons are in the system tray. You have an older software version installed on your system
and it needs to be removed. See “Removing the WNA1000
Software” in Chapter 1 or “Upgrading the WNA1000 Software”
in Chapter 1.
I can connect to the access point, but not to
the other computers on the network or to
the Internet.
This could be a physical layer problem or a network
configuration problem.
1. Check to make sure that the access point is physically
connected to the Ethernet network.
2. Make sure that the IP addresses and the Windows
networking parameters are all configured correctly. See
the link to “Internet Networking and TCP/IP Addressing:” in
Chapter B
.
3. Restart the cable or DSL modem, router, access point, and
computer.
Table 4-1. Troubleshooting Tips (continued)
Problem Action
Page view 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58

Comments to this Manuals

No comments