Netgear MA521 User Manual download pdf (Page 22)

Troubleshooting

The Lnk LED

is off

The MA521 Wireless PC

Card is not associated to

any Access Point properly.

You may not have

configured the wireless

parameters of the wireless

nodes to be the same as the

Access Point.

• The Access Point may not be powered on.

• The Access Point and the MA521 Wireless

PC Card are not configured with the same

wireless parameters. Check the SSID, and

WEP encryption settings.

• The Access Point may be out of range. Try

moving the system closer to the Access Point

or readjusting the antenna on the Access

Point. You may also move the Access Point to

a higher location for better signal reception by

the MA521 Wireless PC Card.

I am associated

and connected

to an Access

Point, but I

cannot see the

other computers

on the Ethernet

side of the

network.

This could be a physical

layer problem or a network

configuration problem.

• Check to make sure that the Access Point

is physically connected to the Ethernet

network.

• Make sure that the IP addresses and the

Windows networking parameters are all

configured correctly.

Problem Cause Solution

No lights are lit

on the Wireless

PC Card

The MA521 Wireless PC

Card is not inserted

properly into the CardBus

slot on your PC. Or the

proper MA521 Wireless PC

Card driver is not loaded.

• Remove and reinsert the MA521 Wireless

PC Card.

• Check the device manager in Windows to see

if the adapter card is properly recognized in

the Windows operating system. Reload the

driver if necessary.

• Try to install the MA521 Wireless PC Card

in different CardBus slot if it’s available.

21

1 2 ... 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments