Netgear GSM7324 User Manual download pdf (Page 17)

Page 16 of 24

To install additional Gigabit Ethernet module, repeat this procedure

Figure 3-3. Installing a Gigabit Ethernet fiber Module into an GSM7324

Step 7: Connecting to the Console Port to Manage the Switch (initial configuration)

To learn the IP address, you must first access the Command Line management via the console interface.

After you power-up the switch for the first time, you can connect to it using a VT100/ANSI terminal or a PC,

Apple Macintosh, or UNIX workstation that is directly connected to the switch’s console port.

To connect a console to the switch:

1. Connect a VT100/ANSI terminal or a PC, Apple Macintosh, or UNIX workstation to the switch’s console

port, labeled Console, using the null-modem cable supplied with the switch. The supplied null-modem

cable has 9-pin connectors on each end.

2. If you attached a PC, Apple Macintosh, or UNIX workstation, start a terminal-emulation program.

Microsoft Windows users can use HyperTerminal, which comes with the Windows operating

systems.

Macintosh users can use ZTerm.

UNIX users can use a terminal emulator such as TIP.

3. Configure the terminal-emulation program to use the following settings:

Baud rate: 9,600 bps

Data bits: 8

Parity: none

Stop bit: 1

Flow control: none

4. Hit the return key, and the below screen should appear.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

No comments

Netgear GSM7324 User Manual Page 17