Netgear FS524 User Manual download pdf (Page 5)

Model FS516/FS524 Fast Ethernet Switch Installation Guide

LEDs

The table below describes the activity of the LEDs.

Vista RJ-45 Network Ports with Built-in LEDs

All of the ports on the switch are 10/100 Mbps capable autosensing Ethernet

ports. Each port supports only unshielded twisted pair (UTP) cable using an 8-

pin RJ-45 plug. Each port uses vista RJ-45 connectors that have two LEDs—the

Link LED and the FDX LED.

Normal/Uplink Push Button

The Normal/Uplink push button on the front panel of the switch allows you to

select uplink (MDI) or normal (MDI-X) wiring for port 16 on the Model FS516

switch and port 24 on the Model FS524 switch. These ports are configured for

normal wiring to connect to a PC when the push button is in the out position.

When the push button is pressed in, these ports are configured for uplink wiring

to connect to another switch or to a hub, using a straight-through twisted pair

cable.

Label Color Activity Description

Pwr (Power) Green On

Off

Power is supplied to the switch.

Power is disconnected.

Rx/Tx/Collision Green

Ye l lo w

Blinking

Packet transmission or reception is occurring

on the port. The blinking action corresponds to

the number of packets that are transmitted or

received.

Data collisions are occurring on the port. The

blinking corresponds to the number of

collisions. When a collision occurs, the

connected device pauses and transmits again

after waiting a specified time.

100 Mbps Green On

Off

The port is operating in 100 Mbps mode.

The port is operating in 10 Mbps mode.

Link Green On

Off

A valid link is established on the port.

A link is not established on the port.

FDX Green On

Off

The port is operating in full-duplex mode.

The port is operating in half-duplex mode.

8923EB

Link

FDX

1 2 3 4 5 6 7 8 9 10 ... 14 15

Comments to this Manuals

No comments

Netgear FS524 User Manual Page 5

Comments to this Manuals

Related products and manuals for Network switches Netgear FS524