Netgear SRX5308 Specifications download pdf (Page 38)

Connecting the VPN Firewall to the Internet

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308

then a new FTP session could start on the WAN2 interface, and then any new

connection to the Internet could be made on the WAN3 interface. This

load-balancing method ensures that a single WAN interface does not carry a

disproportionate distribution of sessions.

3. Click Apply to save your settings.

Configure Protocol Binding (Optional)

 To configure protocol binding and add protocol binding rules:

1. Select Network Configuration > Protocol Binding.

2. Select the Load Balancing radio button. The Protocol Bindings screen displays. (The

following figure shows two examples in the Protocol Binding table.)

Figure 20.

The Protocol Binding table displays the following fields:

• Check box. Allows you to select the protocol binding rule in the table.

• Status icon. Indicates the status of the protocol binding rule:

- Green circle. The protocol binding rule is enabled.

- Gray circle. The protocol binding rule is disabled.

• Service. The service or protocol for which the protocol binding rule is set up.

• Local Gateway. The WAN interface to which the service or protocol is bound.

• Source Network. The computers or groups on your network that are affected by the

protocol binding rule.

• Destination Network. The Internet locations (based on their IP address) or groups

that are covered by the protocol binding rule.

• Action. The Edit table button provides access to the Edit Protocol Binding screen for

the corresponding service.

3. Click the Add table button below the Protocol Binding table. The Add Protocol Binding

screen displays:

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 356 357

No comments

Netgear SRX5308 Specifications Page 38