Netgear ProSafe FSM7352S User Manual download pdf (Page 10)

establish a link with non-stacking interfaces no traffic will pass across the interface. These interfaces

are available to quickly and easily build a stack of switches by simply connecting two or more

FSM7300 switches together with either Category 5 copper Ethernet cables or with SFP-based fiber

connections.

• After ascertaining this information, the switch automatically configures the RJ-45 port to enable

communications with the attached device, without requiring user intervention. In this way, the

Auto Uplink technology eliminates the need for setting uplink connections or being concerned

about whether to use crossover or straight-through cables when attaching devices.

Figure 2-3. Warning! Creating Redundant Paths between Network Devices

SFP module bay

The last four ports (49,50,51,52) on FSM7352S can be used for either STP (RJ45) or SFP (fiber) type

cable. However, both port types cannot be used at the same time. The switch will detect the port in use

automatically simply by the first connected interface. If both connectors are plugged the SFP interface will

operate normally and copper interface will be disabled.

The SFP bay accommodates a standard SFP module which has an LC connector that is compatible with

the IEEE 802.3z 1000BASE-SX standard.

Page 10 of 24

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Netgear ProSafe FSM7352S User Manual Page 10