Netgear FS700TS User Manual download pdf (Page 25)

Installation 3-1

v1.0, December 2005

Chapter 3

Installation

This chapter describes the installation procedures for your NETGEAR Smart Switch. Switch

installation involves the following steps:

Step 1: Preparing the site

Step 2: Installing the switch

Step 3: Checking the installation

Step 4: Connecting devices to the switch

Step 5: Installing an SFP GBIC module

Step 6: Installing device as stand-alone or stack master

Step 7: Apply AC power

Step 8: Switch management through a Web Brower or the PC Utility for initial configuration

Step 1: Preparing the Site

Before you installing the switch, ensure the operating environment meets the operating

environment requirements in the following table.

Table 3-1. Site Requirements

Characteristics Requirements

Mounting Desktop installations: Provide a flat table or shelf surface.

Rack-mount installations: Use a 17-inch (48.3-centimeter) EIA standard equipment

rack that is grounded and physically secure. The rack-mount kit supplied with the

switch is also required.

Access Locate the switch in a position that allows access to the front panel RJ-45 ports, view

the front panel LEDs, and access power connector.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

No comments

Netgear FS700TS User Manual Page 25