Netgear FS700TS User Manual download pdf (Page 22)

Hardware Installation Guide for the Prosafe Stackable Smart Switch FS700TS Series

2-12 Introduction

v1.0, December 2005

System LEDs

The following table describes the system LED designations.

Front Panel Buttons

Reset Button

The Smart Switch has a Reset Button to trigger a hardware reset of the switch. This is equivalent to

turning the power off and back on. The last saved configuration will be loaded onto the switch as it

resets. The LEDs on the switch should go out and then come back on as the switch goes through its

Power On Switch Test (POST).

Factory Defaults Button

The Smart Switch has a Factory Default Button to enable the clearing out of the current

configuration and returning the device back to the factory settings. This will remove all settings,

including the password, VLAN settings and port configurations. If the switches are in a stack, the

stacking settings are cleared by the Factory Defaults Button.

Port 1-24 Mode Select (FS752TPS only)

See Port 1-24 Mode LED description in Table 2-3.

Table 2-3. System LEDs

LED Designation

Port 1-24 Mode LED Solid Green: Ethernet LED Mode (default)

Solid Yellow: PoE LED Mode

Stack ID LED—One 7-segment

LED Display

Green: Displays Stack ID (1-6).

Stack Master LED Solid Green: Switch acts as a master unit in a stack of switches. The

Stack Master LED is lit if there is an active stack link, and the unit is in

stack mode.

Off: Switch acts as a slave unit in a stack of switches.

Power LED Solid Green: Power is supplied to the switch and is operating normally.

Off: Power is disconnected.

MAX POE LED Solid Yellow: Indicates less than 7W of PoE power is available.

Flashing Yellow: Indicates the PoE MAX LED was active in the

previous two minutes.

Off: There is at least 7W of PoE power available for another device

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

No comments

Netgear FS700TS User Manual Page 22