Netgear WN3000RPv3 Installation Guide download pdf (Page 14)

2. Connect the extender to an existing WiFi network.

3. Plug the Ethernet cable from an Ethernet-enabled device in to the

Ethernet port on the extender.

Install the Extender as an Access Point

You can use the extender as a WiFi access point, which creates a new WiFi

hotspot by using a wired Ethernet connection.

1. Place your extender in the same room as your WiFi router.

Proximity to the WiFi router is required only during the initial setup

process.

2. Plug the extender into an electrical outlet.

The Power LED lights green within one minute. If the Power LED

does not light, press the Power button.

3. Use a WiFi network manager on a computer or WiFi device to ﬁnd and

connect to the NETGEAR_EXT (SSID) WiFi network.

Aer the connection with the computer or WiFi device is established,

the Client Link LED lights.

4. Open a web browser window from the same computer or WiFi device.

The browser takes you directly to the NETGEAR genie Smart Setup.

If you are not automatically directed to NETGEAR genie, launch a web

browser and type www.mywiﬁext.net in the address ﬁeld.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Netgear WN3000RPv3 Installation Guide Page 14