Netgear WG311v3 User Manual download pdf (Page 33)

Reference Manual for the NETGEAR 54 Mbps Wireless PCI Adapter WG311 v3

Configuration 3-5

To Configure an Ad Hoc Mode Profile

Note: Ad-Hoc mode will not work using DHCP settings. Ad-Hoc mode requires either static IP

addresses (such as

192.168.0.1) or other appropriate Windows networking configuration

parameters such as adding IPX protocol support. For instructions on setting up static IP addresses

or IPX protocol settings on a Windows PC, refer to the PC Networking Tutorial included on the

NETGEAR 54 Mbps Wireless PCI Adapter WG311 v3 Resource CD.

Follow the instructions below to configure an Ad-Hoc mode profile.

1. Run the WG311 v3 Configuration Utility.

a. Click the WG311 v3 icon in the Windows system tray to open the Settings Tab page.

Figure 3-3: Settings tab page, Ad Hoc

b. Select Ad Hoc in the Network Type section.

c. Enter the SSID for the Ad-Hoc network.

d. Click Apply.

2. Save your settings in a Profile.

a. Type a descriptive name for the Profile Name.

b. Click Save Profile. All the configuration settings are saved in this profile.

c. Click Apply.

d. Click Close to exit the configuration utility.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 69 70

No comments

Netgear WG311v3 User Manual Page 33