Netgear WC7600 Installation Guide download pdf (Page 5)

Set Up the Wireless Controller

 To set up the wireless controller:

1. Configure your computer with a static IP address of

192.168.0.210 and a subnet mask of 255.255.255.0.

2. Connect one end of the supplied Ethernet cable to the Ethernet

port on your computer and the other end to the Ethernet port on

the front panel of the wireless controller.

3. Connect the supplied power cord from the wireless controller to

an AC power outlet.

4. Verify that the following LEDs on the front panel are lit:

LED Description

Power The green Power LED is lit. If this LED is not lit, check the

connections and check to see if the power outlet is controlled

by a wall switch that is turned off.

Status The Status LED is lit yellow while the wireless controller is

initializing. After approximately two minutes, when the

wireless controller has completed its initialization, the Status

LED turns green.

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Netgear WC7600 Installation Guide Page 5