Netgear ME101 User's Guide download pdf (Page 14)

Using the Browser-based Configuration Software

If you don’t have a Windows-based computer, you use

browser-based configuration software to configure the bridge.

1. Make sure the router or access point is powered up.

2. Power up the bridge.

3. Power down the Ethernet-enabled computer.

4. Connect the provided Ethernet crossover cable between

the computer and the bridge.

5. Power on the computer.

If your wireless network has an IP address other than

192.168.0.yyy, you’ll need to change the IP address on the

bridge before making any other changes.

1. On a Macintosh computer open the

Network control panel (OS X) or the TCP/IP control

panel (OS 9.x). Note the current setting and manually change the IP address of your

computer to 192.168.0.50.

2. Start your browser software.

3. Type http://192.168.0.200 as the

web address and press Return.

You’ll see the Information page.

4. To change the IP address for the

bridge to match your wireless

network, click IP Settings.

5. Type admin as the User ID and

type password as the Password.

6. Click OK.

7. If you have a router that uses

DHCP to assign addresses

dynamically, select Obtain IP

address automatically. Otherwise, select Use the following IP address and type an IP

address for the bridge. The first three sets of numbers (xxx.xxx.xxx.yyy) should be the same

as your access point or router. The last set of numbers (.yyy) should be a set of unique

numbers on your network. For example, if the router uses 192.168.1.1, then 192.168.1.25

is a possible IP address for the bridge.

8. Click Apply. and then click Logout.

9. Restore the computer to its previous network settings. For example, if your network

uses DHCP, return your computer to that setting instead of the manual setting.

Default Ethernet AntennaDC in 5V

ME101 Wireless

Ethernet Bridge

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

No comments

Netgear ME101 User's Guide Page 14