Netgear HE102 User Manual download pdf (Page 2)

Trademarks NETGEAR is a registered trademark of NETGEAR, Inc. Windows is a registered

trademark of Microsoft Corporation. Other brand and product names are trademarks or registered

trademarks of their respective holders. Information is subject to change without notice. All rights

reserved.

Statementof Conditions In the interest of improving internal design, operational function, and/or

reliability, NETGEAR reserves the right to make changes to the products described in this document

without notice. NETGEAR does not assume any liability that may occur due to the use or

application of the product(s) or circuit layout(s) described herein.

FCC WARNING

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment on

and off, the user is encouraged to try to correct the interference by on or more of the following

measures:

♦ Reorient or relocate the receiving antenna.

♦ Increase the separation between the equipment and the receiver.

♦ Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

♦ Consult the dealer or an experienced radio/TXV technician for help. Modifications made to the

product, unless expressly approved by NETGEAR, Inc., could void the user’s authority to

operate the equipment.

♦ RF Exposure Requirements WARNING!! To ensure compliance with FCC RF exposure

requirements, the antenna used for this device must be installed to provide a separation

distance of at least 20 cm (8 in) from all persons and must not be co-located or operating in

conjunction with any other antenna or radio transmitter. Installers and end-users must follow

the installation instructions provided in this user guide.

Radio Frequency Interference Requirements This device is restricted to indoor use due to its

operation in the 5.15 to 5.25 GHz frequency range. FCC requires this product to be used indoors

for the frequency range 5.15 to 5.25 GHz to reduce the potential for harmful interference to co-

channel Mobile Satellite systems. High power radars are allocated as primary users of the 5.25 to

5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and /or

damage this device.

Canadian Department of Communications Radio Interference Regulations This digital apparatus

(Model HE102 Wireless Access Point) does not exceed the Class B limits for radio-noise

emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian

Department of Communications.

1 2 3 4 5 6 7 ... 30 31

No comments

Netgear HE102 User Manual Page 2