Netgear HR314 User Manual download pdf (Page 10)

Macintosh Operating System

Mac OS

8.6 or 9.x

1. Choose Control Panels >TCP/IP from the Apple

menu.

2. If not already selected, select Ethernet in the

Connect via list.

3. Select Using DHCP Server in the Configure list.

4. Click the close box.

5. If asked if you want to save this configuration,

click Save.

6. Go to Restarting the Network.

Mac OS X

1. Choose System Preferences from the Apple menu.

2. Double-click Network.

3. If not already selected, select Built-in Ethernet in the Configure list.

4. If not already selected, select Using DHCP in the TCP/IP tab.

5. Click Save.

6. Go to Restarting the Network.

Linux

or UNIX

Operating System

If you’re installing the router with a Linux-based or UNIX-based computer see your system

documentation for TCP/IP and networking setup information.

Restarting the Network

Once you’ve set up your computer to work with the router, you must reset the network for the

devices to be able to communicate correctly.

1. Turn off the DSL or cable modem, wait 15 seconds, and then turn it on again.

Note: If the modem doesn’t have an on/off switch, either pull the modem’s power

adapter out of the wall socket or power down the power strip.

2. If the router was powered down, power it up again and wait until the Test light turns off.

3. Restart the computer that is connected to the router.

Note: You may also configure the router from a wireless PC. In that case, set the

PC’s SSID to the router’s default SSID: Wireless and be sure to Disable WEP encryption.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Netgear HR314 User Manual Page 10