Netgear WG111 User Manual download pdf (Page 40)

User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111

4-2 Configuration

202-10026-01

For example, if you use your notebook PC to connect to a wireless network in an office and a

wireless network in your home, you can create a profile for each wireless network. Then, you can

easily load the profile that has all the configuration settings you need to join the network you are

using at the time.

There are two types of wireless network connections you can configure:

• Infrastructure Mode — uses the 802.11 infrastructure mode.

• Ad-hoc Mode — uses the 802.11 ad-hoc mode

For more information on 802.11 wireless network modes, see “Wireless Networking Overview”

on page B-1 of this manual.

Connecting to an Access Point in Infrastructure Mode

This section provides instructions for configuring the NETGEAR 54 Mbps Wireless USB 2.0

Adapter WG111 to connect to a wireless access point.

How to Configure an Infrastructure Mode Profile

Follow the instructions below to configure an infrastructure mode profile for connecting to an

access point.

1. Run the WG111 Configuration Utility.

a. Make sure the WG111 software is installed and the WG111 is connected to your PC.

b. Open the configuration utility by clicking on the WG111 icon in the Windows system tray.

c. Click on the Settings tab to display the view shown above.

2. Configure the wireless Network settings.

a. In the Network Type section, be sure that Infrastructure is selected.

b. Enter the SSID. This is also called the Wireless Network Name.

Note: You will not get a wireless network connection unless the network SSID matches

exactly what is configured in the access point.

Tip: You can click the Network tab to view a list of the available wireless networks and

their SSIDs at the location where you are.

3. Save your settings in a Profile.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 76 77

No comments

Netgear WG111 User Manual Page 40