Netgear DG834Gv5 User Manual download pdf (Page 17)

Installing Your Router Manually (Advanced, Mac, and Linux Users) 13

Connecting Your Wireless Modem Router

Before you install your wireless modem router, make sure that the Internet Protocol (TCP/IP)

Property settings on your computer are set to “automatically obtain an IP address” using DHCP

and “Obtain DNS server address automatically.” You can check these settings by looking at the

TCP/IP Properties of your Internal Network Connections, which are accessible through the

Control Panel of your computer. If you are unsure about this, refer to the documentation for your

computer or see the link to TCP/IP Addressing in “Related Documents” on page 37.

To connect the wireless modem router, the ADSL filter and the computer:

Connect an ADSL filter as shown below.

You must install an ADSL filter for every telephone that uses the same phone line as your

wireless modem router

a. Select the filter and splitter that you need based on the type of phone line at your location.

If you are replacing an existing router, disconnect it completely from your network

and set it aside before starting to install your new router.

If you purchased the DG834G in a country where an ADSL filter is not included,

you must acquire one.

Figure 7

1 One-Line Filter. Use with a phone or fax machine.

2 Splitter. Use with a one-line filter to share an outlet

with a phone and the modem router

3 Two-line filter with splitter. Use to share an outlet

with a phone and the modem router

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

No comments

Netgear DG834Gv5 User Manual Page 17