Netgear POE101 User Manual download pdf (Page 4)

Connect a Matched Pair of

POE101 Adapters

Note: Use only in pairs of one base and one terminal unit only. Do NOT use two

POE101 base units or two POE101 terminal units together.

1. Connect a straight-through category 5 Ethernet cable (not included in the package) from

the Ethernet switch or hub to the POE101 base unit’s “LAN IN” port.

2. Plug in the the power to the POE base unit.

Verify the POE101 base unit’s LED lights are lit.

3. Connect the a long straight-through category

5 AWG24

Ethernet cable (not included in the

package) from the POE101 base unit’s “LAN

OUT” port to the terminal unit’s “LAN IN”

port. Verify that the POE101 terminal unit has power by checking to see that the LED is lit.

Warning: Do not connect the base unit LAN OUT direct to any Ethernet device. The

power output may damage the device.

4. Connect the provided Ethernet cable from the

POE101 terminal unit’s “LAN OUT” port to

the wireless access point’s LAN port.

5. Connect the DC power cable from the

POE101 terminal unit’s “PWR” port to the

wireless access point’s power socket.

Note: if you cannot plug in the DC power

cable to the access point, use the other DC power cable. There are two DC power

cables provided in the POE101 box. They both have a common plug head for the

POE101 terminal unit’s “PWR” port. However, the other end of one has a the smaller

plug head for North American use while the other cable has a bigger head for

European use.

POE101Base unit: LAN in, Power in

POE101 Terminal unit:

"LAN IN"

LAN IN

POE101 Base unit:

"LAN OUT"

LAN OUT

POE101 Terminal unit: LAN out, Power Out

DC 5V OUT LAN OUTPWR

3 By using a lower AWG numbered cable, you will get a better power transfer efficiency. However, the cable may be thicker.

1 2 3 4 5 6 7 8

No comments

Netgear POE101 User Manual Page 4