Netgear ReadyNAS 4200 Manual download pdf (Page 9)

Chapter 1: Getting Started | 9

ReadyNAS 4200 Hardware Manual

Choosing a Setup Location

Note: This product is intended for installation in a restricted access

location (dedicated equipment rooms, service closets, and the like)

only.

Leave enough clearance in front of the rack to enable you to open the front door completely

(about 25 inches) and approximately 30 inches of clearance in the back of the rack to allow

for sufficient airflow and ease in servicing.

Preparing for Setup

Read these instructions in their entirety before you begin. Locate the ReadyNAS 4200

shipping carton, remove the rack mounting kit and prepare to work with it.

Installing the System into a Rack

To install the system into a rack:

1. The rack mounting kit contains two rail assemblies. Each assembly consists of two

sections: an inner fixed chassis rail that secures directly to the ReadyNAS 4200 chassis

and an outer fixed rack rail that secures directly to the rack itself. Extend the rail

assembly by pulling it outward. Press the release tab and separate the inner rail from

the outer assembly.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 38 39

No comments

Netgear ReadyNAS 4200 Manual Page 9