Netgear WGE101 User Manual download pdf (Page 4)

WGE101 Default Wireless Configuration Settings

The factory default settings for your WGE101 54 Mbps Wireless Ethernet Bridge are:

• Mode (Infrastructure or Ad-Hoc): Infrastructure

• Wireless network name Service Set Identification (SSID): Any

Note: Any means the bridge will connect to the access point or wireless router that has the

strongest signal. This may not be the closest access point or wireless router. For the WGE101

Wireless Ethernet Bridge to communicate with a specific wireless router or access point, both

devices must be configured with the same SSID.

• User ID: admin

• Password: password

• Authentication type: Auto

• WEP security: Disabled

• Country/Region: United States

Warning:

Having the bridge set to the wrong country or region may result in the violation of

local laws.

WGE101-specific default settings:

• IP address:

192.168.0.201

• Protocol: Static

• Device name: netgearxxxx (where xxxx is the last 4 digits of the MAC address)

• Data rate: b/g combo

1 2 3 4 5 6 7 8 9 ... 16 17

No comments

Netgear WGE101 User Manual Page 4