Netgear GS700TR User Manual download pdf (Page 16)

GS700TR Series Hardware Installation Guide

2-8 Physical Description

v1.0, December 2007

System LEDs

The following table describes the system LED designations.

Device Hardware Interfaces

RJ-45 Ports

RJ-45ports are auto-sensing ports. When inserting a cable into an RJ-45 port, the switch

automatically ascertains the maximum speed (10, 100 or 1000 Mbps) and duplex mode (half- or

full-duplex) of the attached device. All ports support only unshielded twisted-pair (UTP) cable

terminated with an 8-pin RJ-45 plug.

To simplify the procedure for attaching devices, all RJ-45 ports support Auto Uplink. This

technology allows attaching devices to the RJ-45 ports with either straight-through or crossover

cables. When inserting a cable into the switch’s RJ-45 port, the switch automatically:

• Senses whether the cable is a straight-through or crossover cable.

2/4-SFP Ports - One LED/

Port

SFP Link/ACT LED • Solid Green - A valid 1000Mbps SFP

module link is established on the port.

• Flashing Green - Packets transmission or

reception is occurring on the port at

1000Mbps.

• Solid Yellow - A valid 100Mbps SFP

module link is established on the port.

• Flashing Yellow - Packets transmission or

reception is occurring on the port at

100Mbps.

• Off - No SPD link is established on the port.

Table 2-2. System LEDs

LED Designation

Power LED • Solid Green - Power is supplied to the switch and is operating

normally.

• Off - Power is disconnected.

Fan LED • Yellow - The fan is not operating normally.

• Off - The fan is operating normally.

Table 2-1. Port LEDs (continued)

Port LED Designation

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

No comments

Netgear GS700TR User Manual Page 16