Netgear WN802T User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 78
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
RangeMax NEXT Wireless-N Access Point WN802T Reference Manual
2-10 Installation and Configuration
v1.0, August 2007
Deploying the RangeMax NEXT
Now that you have completed the setup steps, you can deploy the WN802T in your network. If
needed, you can now reconfigure the computer you used in step 1 in “Configuring the RangeMax
NEXT” on page 2-3 back to its original TCP/IP settings.
To deploy the RangeMax NEXT:
1. Disconnect the WN802T and position it where it will be deployed. The best location is
elevated, such as wall mounted or on the top of a cubicle, at the center of your wireless
coverage area, and within line of sight of all the mobile devices.
2. Connect an Ethernet cable from your RangeMax NEXT to a LAN port on your router, switch,
or hub. Connect the power adapter to the wireless access point and plug the power adapter into
a power outlet. The PWR, LAN, and Wireless LAN LEDs and should light up
Installing the Wall Mount Kit (Optional)
Before you begin installation, check to make sure that the four screws selected to secure the
brackets fit flush within the molding of the bracket. An illustration of the installation steps is
shown in Figure 2-5 on page 2-11.
To install the wireless access point mounting brackets:
1. Place the bottom bracket on the wall where you want to install the WN802T. Securely screw
the bottom bracket into the wall, making sure the screws are flush with the bracket (Step 1).
2. Snap the WN802T into place on the bottom bracket (Step 2). The tabs on the bottom of the
bracket will snap into the slots on the bottom of the WN802T.
3. Firmly secure the top bracket onto the WN802T and attach the bracket with two additional
screws (Step 3). Ensure that the bracket flange engages with the top lip of the WN802T before
screwing in the bracket.
Should you need to remove the WN802T, unscrew the top bracket, and then unsnap the WN802T
from the bottom bracket. Never try to remove your wireless access point before removing the top
bracket.
Tip: Before mounting the WN802T in a high location, first set up and test the WN802T
to verify wireless network connectivity.
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 77 78

Comments to this Manuals

No comments