RangeMax NEXT Wireless-N Access Point WN802T Reference Manual
1-2 Introduction
v1.0, August 2007
• Delivers stable, application enhancing connections using Steady-Stream technology.
• Wi-Fi Protected Access 2 (WPA2) encryption and authentication
• RADIUS authentication support
• Easy, Web-based setup for installation and management.
• NetBIOS login capability
.
• Front panel LEDs for easy monitoring of status and activity.
• Flash memory for firmware upgrades.
• Wi-Fi Multimedia (WMM) Quality of Service (QoS) which allows time-dependent
information, such as video or audio, to have a higher priority than normal traffic.To implement
WMM correctly, wireless clients must also support WMM. (Not available in Client Mode.)
• Operates in three modes for maximum flexibility:
– Access Point. In this mode, operates as a standard 802.11b/g wireless access point.
– Wireless Multi-Point Bridging. In this mode, acts as the “master” for a group of bridge-
mode wireless stations.
– Repeater with Wireless Client Association. In this mode, operates as both a wireless
access point and a wireless bridge.
System Requirements
Before installing the WN802T, make sure your system meets these requirements.
• A 10/100/1000 Mbps Local Area Network device such as a hub, router, or switch.
• The Category 5 UTP straight through Ethernet cable with RJ-45 connector included in the
package, or one like it.
• A 100-240 V, 50-60 HZ AC Switching Power Supply.
• A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, Netscape
Navigator 4.78 or above or Mozilla Firefox.
• At least one computer with the TCP/IP protocol installed.
• 802.11b/g/Next or 802.11b/g -compliant devices.
Comments to this Manuals