Netgear WMS105-10000S User Manual download pdf (Page 14)

14 | Chapter 3: Wireless Configuration

ProSafe 5 AP Wireless Management Software WMS105

experiences interference on a channel, the Wireless Management Software allocates

a different channel to that access point.

• Client aware RF Management: If this Enable radio button is selected, the Wireless

Management Software will not modify the channel for an access point with associated

clients that would be impacted by the channel change. The Wireless Management

Software will wait for the next scheduled channel allocation to adjust the channel.

• Usage-aware RF Management: If this Enable radio button is selected, the Wireless

Management Software will not modify the channel for an access point that is

switching more than 1Mbps of wireless data traffic.

• Run Channel Allocation at: Specify at what time of the day the channel allocation

can modify access point RF configuration.

• Run Channel Allocation every: Specify weekly schedule for running channel

allocation.

• Run Channel Allocation now: Press button to run channel allocation immediately.

3. Enter the Custom RF Settings:

• Mode Settings: Specify the radio mode preference to set on the access points.

Most access points are configured with the fastest mode by default. You can use the

Mode Settings field to change this. For example, you could specify that an access

point that supports wireless-n mode run in b/g mode in order to support clients that do

not support wireless n technology.

• 2.4GHz or 5GHz band selection: This selection affects only dual band access points

that can only be set to one band at a time such as the WNDAP330. You can use this

field to specify which band the access point should use.

Note: For dual concurrent access points, both radio modes are enabled by

default.

4. Click Apply so that your changes take effect.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

No comments

Netgear WMS105-10000S User Manual Page 14