Netgear WGR614 v4 User Manual Page 77
- Page / 152
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Reference Manual for the 54 Mbps Wireless Router WGR614 v4
Advanced Configuration 6-11
December 2003
1.
Click the Add button to open the Add/Edit Menu, shown below.
Figure 6-5. Static Route Entry and Edit Menu
2.
Type a route name for this static route in the Route Name box under the table.
(This is for identification purpose only.)
3. Select Private if you want to limit access to the LAN only. The static route will not be reported
in RIP.
4. Select Active to make this route effective.
5. Type the Destination IP Address of the final destination.
6. Type the IP Subnet Mask for this destination.
If the destination is a single host, type 255.255.255.255.
7. Type the Gateway IP Address, which must be a router on the same LAN segment as the router.
8. Type a number between 1 and 15 as the Metric value.
This represents the number of routers between your network and the destination. Usually, a
setting of 2 or 3 works, but if this is a direct connection, set it to 1.
9. Click Apply to have the static route entered into the table.
As an example of when a static route is needed, consider the following case:
• Your primary Internet access is through a cable modem to an ISP.
• You have an ISDN router on your home network for connecting to the company where
you are employed. This router’s address on your LAN is 192.168.0.100.
• Your company’s network is 134.177.0.0.
- Reference Manual for the 1
- 54 Mbps Wireless Router 1
- WGR614 v4 1
- Trademarks 2
- Statement of Conditions 2
- Frequency Notice 3
- Contents 7
- Chapter 1 13
- About This Manual 13
- How to Use this Manual 14
- How to Print this Manual 15
- 4 About This Manual 16
- Chapter 2 17
- Introduction 17
- 802.11g Wireless Networking 18
- Security 19
- Extensive Protocol Support 19
- Maintenance and Support 20
- Package Contents 21
- The Router’s Front Panel 22
- The Router’s Rear Panel 23
- 2-8 Introduction 24
- Connecting the WGR614 v4 28
- Cable or 29
- DSL modem 29
- Chapter 3 39
- Wireless Configuration 39
- Wireless Data 40
- Security Options 40
- Range: Up to 300 Foot Radius 40
- Wireless Configuration 3-3 41
- 3-4 Wireless Configuration 42
- Wireless Configuration 3-5 43
- Default Factory Settings 44
- Wireless Configuration 3-7 45
- How to Configure WEP 49
- 3-12 Wireless Configuration 50
- Chapter 4 51
- Content Filtering 51
- 4-2 Content Filtering 52
- Content Filtering 4-3 53
- 4-4 Content Filtering 54
- Figure 4-4: Schedule menu 54
- Content Filtering 4-5 55
- Figure 4-5: Logs menu 55
- 4-6 Content Filtering 56
- Table 4-2. Log action buttons 56
- Content Filtering 4-7 57
- Figure 4-6: Email menu 57
- 4-8 Content Filtering 58
- Chapter 5 59
- Maintenance 59
- 5-2 Maintenance 60
- Upgrading the Router Software 63
- Configuration File Management 64
- Maintenance 5-7 65
- Erasing the Configuration 66
- Chapter 6 67
- Advanced Configuration 67
- Configuring WAN Setup Options 70
- Using a Dynamic DNS Service 72
- Using LAN IP Setup Options 73
- 6-8 Advanced Configuration 74
- Using Address Reservation 75
- 6-14 Advanced Configuration 80
- Chapter 7 81
- Troubleshooting 81
- LEDs Never Turn Off 82
- LAN or WAN Port LEDs Not On 82
- Troubleshooting 7-3 83
- 7-6 Troubleshooting 86
- Problems with Date and Time 87
- 7-8 Troubleshooting 88
- Appendix A 89
- Technical Specifications 89
- A-2 Technical Specifications 90
- Interface Specifications 90
- Appendix B 91
- IP Addresses and the Internet 92
- Subnet Addressing 94
- Table 7-2. Netmask Formats 96
- Private IP Addresses 97
- Related Documents 99
- Domain Name Server 99
- IP Configuration by DHCP 100
- Ethernet Cabling 101
- Category 5 Cable Quality 102
- Inside Twisted Pair Cables 103
- December 2003 104
- Preparing Your Network 107
- Appendix C 107
- C-2 Preparing Your Network 108
- Preparing Your Network C-5 111
- Verifying TCP/IP Properties 112
- Preparing Your Network C-7 113
- C-8 Preparing Your Network 114
- Preparing Your Network C-9 115
- C-10 Preparing Your Network 116
- Preparing Your Network C-11 117
- C-12 Preparing Your Network 118
- Preparing Your Network C-13 119
- Properties button 120
- 3. Type ipconfig /all 121
- MacOS 8.6 or 9.x 122
- 4. Click Save 123
- Are Login Protocols Used? 124
- 4. Select the IP Address tab 125
- 5. Select the Gateway tab 125
- Computers 126
- Restarting the Network 127
- C-22 Preparing Your Network 128
- Appendix D 129
- Wireless Networking Basics 129
- Authentication and WEP 130
- 802.11 Authentication 131
- Open System Authentication 131
- Shared Key Authentication 132
- Overview of WEP Parameters 133
- Key Size 134
- WEP Configuration Options 134
- Wireless Channels 135
- Glossary 137
- 2 Glossary 138
- 4 Glossary 140
- X.500-lite 141
- 6 Glossary 142
- 8 Glossary 144
- 10 Glossary 146
- 12 Glossary 148
Related products and manuals for WLAN access points Netgear WGR614 v4
WLAN access points Netgear MA101 User Manual
(67 pages)
(67 pages)
WLAN access points Netgear 802.11g User Manual
(108 pages)
(108 pages)
WLAN access points Netgear WG602v2 User's Guide
(122 pages)
(122 pages)
WLAN access points Netgear ME102 User Manual
(17 pages)
(17 pages)
WLAN access points Netgear WAG302v1 User Manual
(108 pages)
(108 pages)
© 2020, manymanuals.com. All rights reserved. | 0.096 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals