Netgear WAG102 User Manual Page 84

  • Download
  • Add to my manuals
  • Print
  • Page
    / 102
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 83
ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
4-8 Advanced Configuration
v2.0, September 2006
Configure the WAG102 (AP3) in Repeater mode with the Parent AP MAC Address of
AP2.
3. Verify the following parameters for all access points:
Verify that the LAN network configuration the WAG102 Wireless Access Points are
configured to operate in the same LAN network address range as the LAN devices.
All access points must be on the same LAN. That is, all the LAN IP addresses of the
access points must be in the same network.
If using DHCP, all WAG102 Wireless Access Points should be set to “Obtain an IP
address automatically (DHCP Client)” in the IP Address Source portion of the Basic IP
Settings menu.
All WAG102 Wireless Access Points use the same SSID, Channel, authentication mode, if
any, and encryption in use.
4. Verify connectivity across the LANs.
A computer on any LAN segment should be able to connect to the Internet or share files and
printers with any other PCs or servers connected to any of the three WLAN segments.
Figure 4-6
AP in Repeater Mode
with client associations
LAN
Segment 1
192.168.0.1
Router
AP in Repeater Mode
with client associations
AP in Repeater Mode
with client associations
AP1
ETHERNET
RESET
5-12VDC
AP3
ETHERNET
RESET
5-12VDC
AP2
ETHERNET
RESET
5-12VDC
Wireless PC
Associated with AP3
Wireless PC
Associated with AP2
Wireless PC
Associated with AP1
Page view 83
1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 101 102

Comments to this Manuals

No comments