Netgear WAG102 User Manual Page 82

  • Download
  • Add to my manuals
  • Print
  • Page
    / 102
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 81
ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
4-6 Advanced Configuration
v2.0, September 2006
Configuring a Point-to-Multi-Point Wireless Bridge
To configure a point-to-multi-point wireless bridge as shown in Figure 4-5:
1. Under Advanced on the maim menu, select Advanced Access Point Settings 11a or Advanced
Access Point Settings 11b/g. The Advanced Access Point Settings screen will display.
2. Configure the Operating Mode of the WAG102 Wireless Access Points.
WAG102 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode with the Remote MAC
Address of AP2.
Because it is in the central location, configure WAG102 (AP2) on LAN Segment 2 in
Point-to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are required
in AP2.
Configure the WAG102 (AP3) on LAN 3 in Point-to-Point Bridge mode with the Remote
MAC Address of AP2.
3. Verify the following parameters for all access points:
Verify that the LAN network configuration the WAG102 Wireless Access Points are
configured to operate in the same LAN network address range as the LAN devices
Only one access point is configured in Point-to-Multi-Point Bridge mode, and all the
others are in Point-to-Point Bridge mode.
All access points must be on the same LAN. That is, all the APs LAN IP address must be
in the same network.
Figure 4-5
'Master' AP in
Point-to-Multi-Point
Bridge Mode
LAN
Segment 1
192.168.0.1
Router
AP in
Point-to-Point
Bridge Mode
Hub or Switch
LAN
Segment 3
AP in
Point-to-Point
Bridge Mode
LAN
Segment 2
Hub or Switch
AP1
ETHERNET
RESET
5-12VDC
AP3
ETHERNET
RESET
5-12VDC
AP2
ETHERNET
RESET
5-12VDC
Page view 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 101 102

Comments to this Manuals

No comments