Netgear WAG102 User Manual Page 81

  • Download
  • Add to my manuals
  • Print
  • Page
    / 102
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 80
ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
Advanced Configuration 4-5
v2.0, September 2006
Configuring a WAG102 as a Point-to-Point Bridge
To configure a point-to-point bridge as shown in Figure 4-4:
1. Under Advanced on the main menu, select Advanced Access Point Settings 11a or Advanced
Access Point Settings 11b/g. The Advanced Access Point Settings screen will display.
2. Configure the WAG102 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.
3. Configure the WAG102 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode.
AP1 must have AP2’s MAC address in its Remote MAC Address field and AP2 must have
AP1’s MAC address in its Remote MAC Address field.
4. Configure and verify the following parameters for both access points:
Verify that the LAN network configuration of the WAG102 Wireless Access Points both
are configured to operate in the same LAN network address range as the LAN devices
Both use the same ESSID, Channel, authentication mode, if any, and security settings if
security is in use.
5. Verify connectivity across the LAN 1 and LAN 2.
A computer on either LAN segment should be able to connect to the Internet or share files and
printers of any other PCs or servers connected to LAN Segment 1 or LAN Segment 2.
6. Click Apply to save your settings.
Figure 4-4
LAN
Segment 1
Router
AP in
Point-to-Point
Bridge Mode
AP in
Point-to-Point
Bridge Mode
LAN
Segment 2
Hub or Switch
AP1
ETHERNET
RESET
5-12V DC
AP2
ETHERNET
RESET
5-12V DC
Page view 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 101 102

Comments to this Manuals

No comments