Netgear XSM7224S User Manual download pdf (Page 522)

100

101

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

Log Messages 8-24

v1.0, November 2010

OS In hapiBroadSystemMacAddress call to

'bcm_l2_addr_add' - FAILED : x

Failed to add an L2 address to the MAC

table. This should only happen when a hash

collision occurs or the table is full.

OS Failed installing mirror action - rest of the

policy applied successfully

A previously configured probe port is not

being used in the policy. The release notes

state that only a single probe port can be

configured

OS Policy x does not contain rule x The rule was not added to the policy due to

a discrepancy in the rule count for this

specific policy . Additionally, the message

can be displayed when an old rule is being

modified, but the old rule is not in the policy

OS ERROR: policy x, tmpPolicy x, size x, data x

x x x x x x x

An issue installing the policy due to a

possible duplicate hash

OS ACL x not found in internal table Attempting to delete a non-existent ACL

OS ACL internal table overflow Attempting to add an ACL to a full table

OS In hapiBroadQosCosQueueConfig, Failed to

configure minimum bandwidth. Available

bandwidth x

Attempting to configure the bandwidth

beyond it’s capabilities

OS USL: failed to put sync response on queue A response to a sync request was not

enqueued. This could indicate that a

previous sync request was received after it

was timed out

OS USL: failed to sync ipmc table on unit=x Either the transport failed or the message

was dropped

OS usl_task_ipmc_msg_send(): failed to send

with x

Either the transport failed or the message

was dropped

OS USL: No available entries in the STG table The Spanning Tree Group table is full in

USL

OS USL: failed to sync stg table on unit=x Could not synchronize unit x due to a

transport failure or API issue on remote unit.

A synchronization retry will be issued

OS USL: A Trunk doesn't exist in USL Attempting to modify a Trunk that doesn’t

exist

OS USL: A Trunk being created by bcmx

already existed in USL

Possible synchronization issue between the

application, hardware, and sync layer

OS USL: A Trunk being destroyed doesn't exist

in USL

Possible synchronization issue between the

application, hardware, and sync layer.

Table 8-52: System General Error Messages

Component Message Cause

1 2 ... 517 518 519 520 521 522 523 524 525 526 527 ... 578 579

Comments to this Manuals

No comments

Netgear XSM7224S User Manual Page 522

Comments to this Manuals

Related products and manuals for Software Netgear XSM7224S